Hi, this is Tracy with FoxFury Lighting Solutions here to tell you about the Rugo 2.
The Rugo 2 is an ultra durable lighting tool for the on-the-go
videographer, photographer and drone pilot. The 620 lumen light has four modes,
low, medium, high and strobe. The Rugo 2 is also 92 CRI with true-to-life LEDs
for better color accuracy for photo and video. The Rugo 2 is fire resistant,
impact resistant and waterproof up to 60 feet. It's all-weather design means that
it will thrive in almost any environment. The Rugo 2 can be seen from up to 3
statute miles away and has a strobe mode of 90 cycles per minute.
Both of these features comply with FAA 107.29 regulations for UAV night
flight. The Rugo 2 comes with extra thumb screws, a quarter 20 mount, a cold
shoe mount, a standard mount, a wall charger and a protective accessories bag.
This allows the Rugo 2 to attach to most action cameras and DSLR cameras. The
units can also attach to each other or be daisy chained to give the user more
lighting power. A variety of drone mounts are also available as separate
accessories. The Rugo 2 features a sliding Tri-lens, which lets the user
choose the light type depending on what they're using the light for. There's a
spot mode, which is ideal for long-range activities. An area light, which is ideal
for mid-range activities. And a floodlight which is ideal for close-up
activities, The Rugo 2 is powered by a quick swap power pack. Battery life lasts
anywhere from 1 to 6 hours, depending on which mode you're using. To separate the
battery pack from the unit, simply press down on the release lever and wiggle the
pack until it comes loose from the light head. You can see the port for the micro
USB adapter here. Simply plug it in and let it recharge. It takes about two and a
half hours to recharge a battery pack fully. Once complete, simply reattach it
to the light head and press in until you hear a click, then you're
good to go. Additional power packs are sold as
separate accessories, so users can swap them out easily without much downtime.
The Rugo 2 has 4 modes, low, medium, high and strobe. The power mode switch is this
orange button on the side of the light head. So you simply press it once to get
to low mode, twice to medium, three times to high and a fourth time to the strobe
mode. When you're ready to turn the light off, simply hold down the power button
for two seconds until the light goes off. To swap out the mounts on the Rugo 2,
you first locate the thumb screws on the top of the light head. Rotate those
counterclockwise until they pull out of the light and then the mount should
separate as well. Now you'll notice on top of the light head there is a notch
that sticks out so you want to align that with the groove that's inside the
mount. You'll hear a small click when that
locks into place. And then on the bottom side of the light, you want to take the
corresponding mount piece and line it up so that this opening goes over top of
the release lever. And then you can put your screws into place rotate those
clockwise until everything is nice and tight and you're good to go.
All of the other mounts that come with the Rugo 2, as well as our drone mounts,
will attach in a similar way. The Rugo 2's compact and lightweight design
make it an ideal lighting tool for the on-the-go photographer and videographer.
Multiple units can fit inside a small bag or backpack and the user can set up
a multi-point lighting system on scene quickly and easily. The Rugo 2 is an
extremely versatile light and has great potential for your photo video and drone
needs. For more information on the Rugo 2, including photos videos and case
studies please visit foxfury.com